- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
while programming through RESET mode I am getting a error message as shown" Programming Terminated Detected SiliconID: "FF FF 13 AA" is not in database".
But when i programm through Power cycle mode programming is getting loaded but once powered on , no response from PSOC4.
Can somebody help with this?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you try programming your device using 1.8V and RESET mode in PSoC Programmer? Let me know if it works.
Refer to this KBA for more information: Silicon ID Mismatch while Programming PSoC® Devices - KBA221305
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you try programming your device using 1.8V and RESET mode in PSoC Programmer? Let me know if it works.
Refer to this KBA for more information: Silicon ID Mismatch while Programming PSoC® Devices - KBA221305
Regards,
Dheeraj