Hello, I am using CY8C4128LQI-BL543

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

while programming through RESET mode I am getting a error message as shown" Programming Terminated  Detected SiliconID: "FF FF 13 AA" is not in database".

But when i programm through Power cycle mode programming is getting loaded but once powered on , no response from PSOC4.

Can somebody help with this?

0 Likes
1 Solution
DheerajK_81
Moderator
Moderator
Moderator
First comment on KBA First comment on blog 5 questions asked

Can you try programming your device using 1.8V and RESET mode in PSoC Programmer? Let me know if it works.

Refer to this KBA for more information: Silicon ID Mismatch while Programming PSoC® Devices - KBA221305

Regards,

Dheeraj

View solution in original post

0 Likes
1 Reply
DheerajK_81
Moderator
Moderator
Moderator
First comment on KBA First comment on blog 5 questions asked

Can you try programming your device using 1.8V and RESET mode in PSoC Programmer? Let me know if it works.

Refer to this KBA for more information: Silicon ID Mismatch while Programming PSoC® Devices - KBA221305

Regards,

Dheeraj

0 Likes