Attachments are accessible only for community members.
Anonymous
Not applicable
Sep 24, 2018
02:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2018
02:08 PM
I have been trying to get this ADC program to work (Vref of VDD, single channel, single ended, no injection) and when I run the debugger, the code does not get past while( !ADC_IsEndConversion(ADC_RETURN_STATUS));. Compressed workspace is attached. What can I do?
Solved! Go to Solution.
1 Solution
Sep 24, 2018
02:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2018
02:21 PM
You need to start the ADC (by calling ADC_Start()), not just starting the conversion. Basic PSoC rule: _any_ component needs to be started.
2 Replies
Sep 24, 2018
02:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2018
02:21 PM
You need to start the ADC (by calling ADC_Start()), not just starting the conversion. Basic PSoC rule: _any_ component needs to be started.
Sep 24, 2018
11:05 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 24, 2018
11:05 PM
Hi,
You have your ADC Sample mode as Free running.
To use Trigger (Start Conversion), I think that you need to set the Sample Mode to Hardware trigger
moto