- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I would like to update a project which was created with PSoC Creator V3.2 to new version PSoC Creator V4.2. The project uses 2 UARTS + 1IC2 Interface on processor CY8C4246AZI-M443 48-LQFP.
On Version PSoC Creator V3.2 no error message appeared when compilating the project.
The UART1 was assigned to P4[0] (RX) and P4[1] (TX)
The UART1 was assigned to P7[1] (RX) and P7[1] (TX)
I"C was assigned to P0[4] and P0[5]
Now with new version of PSoC Creator V4.2 I can create only one UART and one I2C Interface.
What's the problem?
Thanks for any help
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can attached your test project in this forum, I can test it for you.
I try to configure two uart and one I2C in creator, everything is OK.
You need to try to allocate the three component in SCB[0],SCB[1] and SCB[3].
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I also use the CY8C4246AZI-M443 chip, I can assign two uart and one I2C, the same pins as your description.
Do you mean you update the project from creator V3.2 to V 4.2 directly, and meet this issues?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
1) In PSoC Creator 4.2.0.641, please go to Tools -> Find new devices and install device pack.
2) Restart PSoC Creator and let us know if it helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your answer,
I have installed the device pack. Unfortunately the error message still appears
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can attached your test project in this forum, I can test it for you.
I try to configure two uart and one I2C in creator, everything is OK.
You need to try to allocate the three component in SCB[0],SCB[1] and SCB[3].
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Tanks for your answer,
yes, you're right. The error occured after updating PSoC Creator Version V3.2 to 4.2
Which is the version you are using?