- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In bulkloop example ,I changed Standard super speed configuration descriptor as adding an interface.
But it cann't work .I could find another interface.Could tell me how to make as UVC having two interface ?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
- The descriptors look fine. Are you able to see two devices listed on the device manager?
- Similar method of addition of interfaces can be done in the UVC example also. Please refer to the UVC AN75779 app note example. In this firmware code, define the macro USB_DEBUG_INTERFACE to enable the additional vendor interface.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
I wanted to add a interface as you said in the UVC AN75779 app
Your firware is like this:
but when I added like up,the result is like this
I don't know why ,how can i do!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please share the screenshot of the device manager. Check if there is any device under the 'Unknown Devices' section.
Best regards,
Srinath S
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi!
Your firmware is like this:
but when i changed it,it like this:
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content