- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I can program success only in the first time. after that,it always point "There was an error running port acquire: Can not acquire SWD device!" how can i program it again,thanks~
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Leo,
Seems that the KitProg is in CMSIS-DAP mode. Kindly refer this thread.
Kitprog stops working after firmware update (CY8CKIT-059)
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Leo,
Seems that the KitProg is in CMSIS-DAP mode. Kindly refer this thread.
Kitprog stops working after firmware update (CY8CKIT-059)
Thanks,
Ryan
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Rzzh,
Thank you very much !
You solved my problem perfectly.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which kit are you using? By looking at your project, I guess you are using CY8CKIT-042-BLE.
Please make sure that the jumpers on the are at their default position before programming, by referring to the kit guide.
Currently I see that you are using the KitProg in CMSIS-DAP/Mass Storage mode. Try changing the KitProg to default programming mode and then try programming the device, see if that helps. Refer to section 4.1 Enter or Exit the Mass Storage Programmer Mode of KitProg User Guide for steps to change the KitProg mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Srds,
The reason for this mistake is that I accidentally pressed the reset button for more than 5 seconds.
Thank you for your reply.