Anonymous
Not applicable
Jun 22, 2015
07:32 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 22, 2015
07:32 AM
I have modified snip.uart by changing all references to STDIO_UART to WICED_UART_2,
but no data is seen on the TX pin. Is there something else I need to configure to use this UART?
My platform is the ISM43362_MG3_L44.
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Jun 23, 2015
01:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2015
01:50 PM
No, nothing else is needed. I traced the problem to a pin numbering error on the
break-out board we built to plug into the ISM43362_MG3_L44 EVB expansion header.
1 Reply
Anonymous
Not applicable
Jun 23, 2015
01:50 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 23, 2015
01:50 PM
No, nothing else is needed. I traced the problem to a pin numbering error on the
break-out board we built to plug into the ISM43362_MG3_L44 EVB expansion header.