- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi we are planning to use BLE module from Murata(Type 1GR) with CYW20736 and interface it externally with STM32F412 to write our application , Can you let me know which platform on WICED I need to use for the development. If their are any EVK available for this?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately there is not. An external processor could interface to the part using the peripheral UART interface.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unfortunately there is not. An external processor could interface to the part using the peripheral UART interface.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So this module can only be used with AT commands via UART ??
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The part is primarily designed to run self contained in embedded mode as the stack, drivers, patches, etc. are integrated into ROM. I believe there is also close to 30K in RAM for the application to run on the internal CM3. The AT command set is not supported by default.
More here: WICED Smart Hardware Interfaces