Anonymous
Not applicable
Aug 23, 2018
05:26 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 23, 2018
05:26 AM
Dear Sir,
I had the S6AE103A Evaluation Kit and would like to use it to power up an external board.
The external board requires 2.1V and I>10mA. I read the guideline and said the LDO current
can provide 10mA in normal mode. However, when i measure the evaluation kit output current,
is was just a few uA. Could i know under what condition i can get a 10mA output ?
Thanks
Solved! Go to Solution.
Labels
1 Solution
Aug 26, 2018
09:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2018
09:11 PM
Hello,
Please refer to the thread in the following link
Maximum output current limit for Vout 1 and Vout2 pin of S6AE102A / S6AE103A PMICs
Thanks,
Yuva.
1 Reply
Aug 26, 2018
09:11 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2018
09:11 PM
Hello,
Please refer to the thread in the following link
Maximum output current limit for Vout 1 and Vout2 pin of S6AE102A / S6AE103A PMICs
Thanks,
Yuva.