Programming CY8CKIT-059

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
dahec_263886
Level 1
Level 1

Hi

I have been using PSoC Creator 4.2 to program several CY8CKit 059 boards. I jusr received some new (hopefully idential) boards. When I try to program it in the same way, the Select Debug Target dialog pops up but it shows the KitProg and a sub item called ARM Debug Port (which the previous units did not show). When I hit Port Acquire, it finds the ARM Debug port and reports that it cannot program it.

As far as I can see, the boards are the same (both REV006)

How can I program my new boards?

Dave

0 Likes
1 Solution
LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

Try to use the programmer to download your hex to the device.

Where do you get these kits?

Could you add your config figure in the programmer screen shot here.

pastedImage_0.png

View solution in original post

0 Likes
3 Replies
LinglingG_46
Moderator
Moderator
Moderator
500 solutions authored 1000 replies posted 10 questions asked

Try to use the programmer to download your hex to the device.

Where do you get these kits?

Could you add your config figure in the programmer screen shot here.

pastedImage_0.png

0 Likes

I bought both the previous set and the new set from DigiKey (same part numbers).

I used PSoC Creator to build and load the apps previously. Why can't I do it now?

I have  installed PSoC Programmer. I don't know how to use it but I think I just made it work.

I now I seem to be able to build and download code from PSoC Creator.

What changed?

0 Likes

What do you change to make it work?

Use the programmer Utilities, you can update the kitProg. I only want you to have a try, maybe it can solve your problems.

0 Likes