- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a new board with a S25FS QSPI part into which I need to write the U-Boot binary and other pre-boot information for the CPU. I have access to the SPI interface through a 6-pin connector, but I am not finding any obvious solution for a programmer (hardware and/or software) to accomplish.
Where am I not looking that I should be?
Thanks!
.Tim
Solved! Go to Solution.
- Labels:
-
Serial NOR
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tim,
Cypress does not have any in system programmers for flash devices. Please check with any of the programmer manufacturers.
Thanks and Regards,Sudheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Tim,
Cypress does not have any in system programmers for flash devices. Please check with any of the programmer manufacturers.
Thanks and Regards,Sudheesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sudheesh -
Thank you for the confirmation.
.Tim