- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Q1: Could you provide antenna specification.
We need to know antenna gain and radiation pattern like following document.
Q2: Do you have module HW design guideline?
The customer is concerned stainless plate will block radio of the module because there is a such stainless plate in the customer application.
Usually module supplier is providing design guideline to satisfy radio performance so we need to know whether Cypress ready such document.
Q3: Can Cypress support the customer to review module placement based on 3D or layout file of the customer system ?
Thank you.
--Takuya
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For the 3D model of CYBT-343026 refer KBA: 3D Model Files for EZ-BLE/EZ-BT Modules – KBA218122
For board development you can refer the Schematics of CYBT 343026 EVAL : http://www.cypress.com/documentation/development-kitsboards/cybt-343026-eval-ez-bt-module-arduino-ev...
Please have a look at our Module placement KBA as well : EZ-BLE™ Module Placement – KBA97095
Thanks & Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
For the 3D model of CYBT-343026 refer KBA: 3D Model Files for EZ-BLE/EZ-BT Modules – KBA218122
For board development you can refer the Schematics of CYBT 343026 EVAL : http://www.cypress.com/documentation/development-kitsboards/cybt-343026-eval-ez-bt-module-arduino-ev...
Please have a look at our Module placement KBA as well : EZ-BLE™ Module Placement – KBA97095
Thanks & Regards,
Anjana
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Thanks for your answe.
What about Q1 as follows?
Q1: Could you provide antenna specification.
We need to know antenna gain and radiation pattern like following document.
In order to design HW , we really need the specification of antenna.
Thank you.
—Takuya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
anpm
Thanks again.
And, please answer following Q3.
Q3: Can Cypress support the customer to review module placement based on 3D or layout file of the customer system ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, could you help me for that?
If we keep this status, the customer can not move to next step
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Q3: Can Cypress support the customer to review module placement based on 3D or layout file of the customer system ?
A) Yes, we can review the customer board design. Please share schematics and layout files.
Thanks & Regards,
Anjana