Jul 29, 2018
09:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2018
09:33 AM
When i use the psoc6 DEMO , it can't download the hex file ,it shows below error, just LED2 and LED4 ON, other is OFF; what's wrong with it ,thanks;
Solved! Go to Solution.
1 Solution
Jul 29, 2018
09:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2018
09:41 PM
Looks like the device is in Hibernate mode, did you try pressing SW2 or Reset? Did you try to acquire the device from the PSoC Creator? If it was not able to acquire, then what error did it throw?
3 Replies
Jul 29, 2018
10:05 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2018
10:05 AM
Try holding the Reset button down for 10 sec.
Jul 29, 2018
05:28 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2018
05:28 PM
In addition, double-check hardware connection on the board.
Jul 29, 2018
09:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 29, 2018
09:41 PM
Looks like the device is in Hibernate mode, did you try pressing SW2 or Reset? Did you try to acquire the device from the PSoC Creator? If it was not able to acquire, then what error did it throw?