- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How to use Bridge control panel to communicate with PSOC;
I can't find the instructions text files in CYPESS web;
such as:
i don't know +,p what it means and why there are three byte date of ff after a4; please help, thanks;
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
You can navigate to help section (F1) of Bridge control panel and select communication.
Various symbols used in commands and the interpretation of results is available.
P -> Generates a stop condition on the bus
+ -> Append two commands together
It looks like you are reading 4 bytes of data from the I2C slave device.
So, ensure your slave is also configured to send out 4 bytes of data.
Thanks,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi David,
You can navigate to help section (F1) of Bridge control panel and select communication.
Various symbols used in commands and the interpretation of results is available.
P -> Generates a stop condition on the bus
+ -> Append two commands together
It looks like you are reading 4 bytes of data from the I2C slave device.
So, ensure your slave is also configured to send out 4 bytes of data.
Thanks,
Shanmathi