- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I edite a schmetic, just like the first pieture below, bufoe out terminal is inout, i have to connect it to a input terminal, it shows error like the second picture, what can i do?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
There is an issue implementing such design. It is not allowed and component datasheet talks about it.
Imagine a case, when both buffers are enabled and driving the same net with opposite logic, resulting in a short.
I would suggest drive the buffer outputs to bidirectional pins configured in open drain drive low (connect an external resistor high side - this is to support the case when both buffers disabled) and short the pins together externally. For the NAND gate input, use one of the buffer's feedback output signal.
-Rajiv
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you please post your complete project or a shortened version that shows the error so that we all can have a look at all of your settings. To do so, use
Creator->File->Create Workspace Bundle (minimal)
and attach the resulting file.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
There is an issue implementing such design. It is not allowed and component datasheet talks about it.
Imagine a case, when both buffers are enabled and driving the same net with opposite logic, resulting in a short.
I would suggest drive the buffer outputs to bidirectional pins configured in open drain drive low (connect an external resistor high side - this is to support the case when both buffers disabled) and short the pins together externally. For the NAND gate input, use one of the buffer's feedback output signal.
-Rajiv
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
thanks a lot , the setting is safe but not convenient..