CYPD2703-9FNXIT Wire Output

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

I'm trying to make my own USB Type C 3.1 cable and I found the chip CYPD2703-9FNXIT on your site.  I am looking at the reference schematic, but am unsure of where/how to output from the chip to cable.  Any help?

0 Likes
1 Solution

Hi Bryan,

There no need firmware program for the chip. If you want to change any configuration table of the chip, you can configure it via EZ-PD configuration Utility.

Link: http://www.cypress.com/documentation/software-and-drivers/ez-pd-configuration-utility?source=search&...

Best Regards,

Lisa

View solution in original post

0 Likes
3 Replies
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi Bryan,

All of Type-C cable is VCONN powered. The latest VCONN SPEC is 3.0V - 5.0V. And EMCA cable is communication with DFP with CC line.

Best Regards,

Lisa

0 Likes
Anonymous
Not applicable

Would I need to program the chip after it has been terminated to the PCB, or is there a method to program it as a standalone?

0 Likes

Hi Bryan,

There no need firmware program for the chip. If you want to change any configuration table of the chip, you can configure it via EZ-PD configuration Utility.

Link: http://www.cypress.com/documentation/software-and-drivers/ez-pd-configuration-utility?source=search&...

Best Regards,

Lisa

0 Likes