4 Replies Latest reply on Jul 9, 2018 11:51 PM by VasanthR_91

    Implementing an Arc Fault detection circuit using Psoc 4 pioneer kit

      Hello there fellow Psoc members. I am a newbie when it comes to mirco controllers and Psoc technology. I am trying to create a test fixture to measure arc fault for a POE standard to measure the voltage arc for the disconnect action for POE. The set up will have 8 channel read out to the MCU using the ADC ports on the CY8CKIT-042  and external opamp chips INA240A connect to a shunt resistor of .5ohms. The tolerance for error are 5% for current and 2% for the voltage. The circuit diagram has 8 channels that are being monitored for changes in current. Im not sure how to implement it on Psoc using the ADC to replicate the signal going into the MCU?