- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
How to get current active PDO profile used by ccg2 device either in source or sink mode through HPI interface, we added Sink pdo 5V@3A, 9V@3A, 12V@3A, 15V@3A, 20V@3A and Source 5V@3A ,12V@3A , we tried to read 0x24 and 0x25 registers respond with values 0x1F and 0x01 respectively.
we tired to read CURRENT_PDO from ccg2 in sink mode responds with value 0x1003C12C, what this value represents.
Thanks,
Nagaraj
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nagaraj,
For question about HPI, the concerned topics are not suitable for discussing in the community here, please contact your local Cypress/Cypress distributor for your help.
The 0x1003C12C is the PDO format, You can refer PD2.0 PDO format to get details defines.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Nagaraj,
For question about HPI, the concerned topics are not suitable for discussing in the community here, please contact your local Cypress/Cypress distributor for your help.
The 0x1003C12C is the PDO format, You can refer PD2.0 PDO format to get details defines.
Best Regards,
Lisa