- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which PSoC creator to use?
Tom
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Go over to "Tools > Find New Devices" tab in PSoC Creator 4.2 and install the device pack as mentioned in the screenshot attached.
Now create a New Project and when you do the "<Launch Device Selector>" you should see the device listed as shown below:
Click on OK and then you can continue with your project as usual.
If this answer was helpful, do let me know.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please install Prototyping kit complete setup from this link:
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-147-psoc-4100ps-prototyping-kit
Then check the PSoC Creator4.2.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Go over to "Tools > Find New Devices" tab in PSoC Creator 4.2 and install the device pack as mentioned in the screenshot attached.
Now create a New Project and when you do the "<Launch Device Selector>" you should see the device listed as shown below:
Click on OK and then you can continue with your project as usual.
If this answer was helpful, do let me know.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you both!
I'm not sure which suggestion did the trick as I tried both, still didn't get the device, then re-installed the kit and restarted the PSoC creator, then voila, the part is there .
Thanks!
--
Tom