- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In wiced_bt_mesh_core_config_t mesh_config, I can config features with/without WICED_BT_MESH_CORE_FEATURE_BIT_RELAY
to make device support/not support relay feature.
But if I config support relay feature, relay feature is enabled when it's be provisioned.
Is there any place that I can modify to make relay feature is supported but disabled without config by Provisioner.
If all nodes's relay is enabled, I have to config it with "Config Relay Set" to disable the feature.
It's not convenient.
So is proxy feature.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As per the present stack, the relay feature will be enabled during provision.
This has to be individually disabled. It cannot be left disabled during the provision.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
As per the present stack, the relay feature will be enabled during provision.
This has to be individually disabled. It cannot be left disabled during the provision.