Anonymous
Not applicable
Jun 07, 2018
01:03 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 07, 2018
01:03 PM
1 Solution
Jun 07, 2018
11:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 07, 2018
11:24 PM
Hi Dalip,
If you check the pin F6 it is NC on the S29Pl-J device while it is the Byte pin on the S29GL-N device. So, you need to take into account this change and proceed accordingly. Rest all pin-out are same for both the devices.
Thanks,
Pradipta.
2 Replies
Jun 07, 2018
11:24 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 07, 2018
11:24 PM
Hi Dalip,
If you check the pin F6 it is NC on the S29Pl-J device while it is the Byte pin on the S29GL-N device. So, you need to take into account this change and proceed accordingly. Rest all pin-out are same for both the devices.
Thanks,
Pradipta.
Jun 08, 2018
06:00 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 08, 2018
06:00 AM
Hi Pradipta,
Thanks for the answer. I just wanted to confirm it. That F6 pin (tied high or low) configures the device in word or byte mode.
Dalip.