- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
unsupported sdcard is showing when i insert my sdcard to my mobile after programmed through ezusb.whats the reason?
thank you.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Geetha,
If you have performed raw writes to a formatted SD card using FX3S, then file system in the card gets corrupted which causes issue when you read it in your mobile.
This may be the case. Please confirm.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Geetha,
If you have performed raw writes to a formatted SD card using FX3S, then file system in the card gets corrupted which causes issue when you read it in your mobile.
This may be the case. Please confirm.
Regards,
Hemanth
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
yes,thank you
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
the raw data is from gpif 2 interface,how to read this raw data in the pc?any driver or file system on the pc side to read this data?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Geetha,
To read the raw data in the PC, you need to have your own Host application which uses cypress cyusb3.sys driver.
Regards,
Hemanth