- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
I am doing an Eagle drawing for a PCB and need the dimensions and location of the pins of the developmental area of the PSoC 5LP developmental board.
I was wondering if there was an existing drawing I could use. The goal is to import my schematic directly into the PSoC Eagle drawing.
Please advise.
Very Respectfully,
Mark
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you can get the Allegro Cadence compatible only schematic files of PSoC 5LP developmental board which is available at this link:
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-050-psoc-5lp-development-kit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you can get the Allegro Cadence compatible only schematic files of PSoC 5LP developmental board which is available at this link:
http://www.cypress.com/documentation/development-kitsboards/cy8ckit-050-psoc-5lp-development-kit
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
When I try to open the file, I receive the following error:
Error:
line 1, column 1: Start tag expected.
Can you please advise?
Respectfully,
Mark
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
you are trying to open file .dsn in which tool? Eagle can't open the .dsn files