Anonymous
Not applicable
May 14, 2018
12:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 14, 2018
12:10 AM
Hello: When I create a UVC+HID compliant device, I encounter a problem. After the UVC and HID enumeration is completed, the host issues the SET FEATURE command (content: 01 03 00 00 02 01 00 00) when the host sends this. After the command, HID cannot send a report, but UVC works normally. If I start UVC and send a report to start HID before the host sends SET FEATURE, both UVC and HID are working properly. Why?
Solved! Go to Solution.
1 Solution
May 18, 2018
02:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2018
02:16 AM
3 Replies
Attachments are accessible only for community members.
Anonymous
Not applicable
May 14, 2018
12:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 14, 2018
12:12 AM
May 17, 2018
01:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2018
01:49 AM
In the first case (HID not working one), what the device response to the Report?
Can you share the uvc.c file for the review?
May 18, 2018
02:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 18, 2018
02:16 AM
Hi
Do you use Win7 or Win10?