- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Guys,
My hardware is : cx3+ov5640.
when I used the following sample code, It worked fine.
C:\Cypress\EZ-USB FX3 SDK\1.3\firmware\cx3_examples\cycx3_uvc_ov5640
But when I used CX3 configuration tools to generate a new project with ov5640 sensor,
I got an exclamation mark in device manager.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your code works fine on my side.
Please try to uninstall the device in device manager and let it re-install driver again.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
MIPI configuration wise, there is no difference between both the projects.
Looks like there is a problem with the enumeration.
Some part of the code might have missed.
Please check whether the modified project included all the files.
And also compare all .c and .h files.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you upload your project. I could check on my side.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Your code works fine on my side.
Please try to uninstall the device in device manager and let it re-install driver again.