fx3 usb2.0 enumeration problem

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

HI,

Our custom board(fx3s) is some times failed to enumerate as usb device.some times it works pretty,some times its require power off and on.what is the reason?

thank you.

0 Likes
1 Solution

Hi,

FX3S can support GPIF of 16 bit only. If you load a firmware with GPIF 32 bits enabled it will run into error state and it will stuck there forever and hence it will stop enumeration.

Regards

Abhinav

View solution in original post

0 Likes
7 Replies
YangyangC_06
Employee
Employee
750 replies posted 500 replies posted 250 replies posted

Hi geetha,

Please check your design according to AN70707. We also provide the schematic/PCB files for CYUSB3KIT-003.

You could also review your design taking these as reference.

Anonymous
Not applicable

hello,

its working fine for other examples in the same hardware,but not for the slavefifo.

thank you.

0 Likes

Do you use FX3 or FX3S?

0 Likes
Anonymous
Not applicable

its fx3s CYUSB3035-BZXI

THANK YOU

0 Likes

FX3S is for storage application. Why do you test it with slave FIFO firmware?

Can you send your firmware in this discussion? But I am not sure if I could find CYUSB3035 board to dobule check.

0 Likes
Anonymous
Not applicable

FX3S is for storage application. Why do you test it with slave FIFO firmware?

-->Its supports storage port also and aslo supports slavefifo.am i right?

0 Likes

Hi,

FX3S can support GPIF of 16 bit only. If you load a firmware with GPIF 32 bits enabled it will run into error state and it will stuck there forever and hence it will stop enumeration.

Regards

Abhinav

0 Likes