- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello I am currently using the sparkfun 2 , and in my project i am using ADC is it posibbile to see the resolt of the adc on the computer screen and not only on external LCD screen (for exmpale in arduino to see the resolt on the cumputer you press serial command ) is there a comnd similar to the Serial like in Arduino but in Cypress ?
Solved! Go to Solution.
- Tags:
- adc
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That depends. For the Cypress kits there is a USB-UART bridge implemented in the interface (program and debugging) part. So just wiring the UART Rx and Tx lines to the appropriate inputs will allow to use PuTTY to display data. Use sprintf() and UART_PutString() routines. Take care when printing floats, you'll need to increase heap size to 0x0200.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
That depends. For the Cypress kits there is a USB-UART bridge implemented in the interface (program and debugging) part. So just wiring the UART Rx and Tx lines to the appropriate inputs will allow to use PuTTY to display data. Use sprintf() and UART_PutString() routines. Take care when printing floats, you'll need to increase heap size to 0x0200.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ok thank you it is more complicated than doing on the lcd