- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I need to configure the ccg2 on the development board as the eMarker to simulate the cable.
Can i use the miniProg3 to configure the ccg2?
Thanks.
John
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi John,
The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.
If you want to update firmware image totally, you need MiniProg3.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi John,
The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.
If you want to update firmware image totally, you need MiniProg3.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi lisa
How to update configure table of CCG2?
If I want to change the VDO setting, I just update the configure table?
Thanks.
John