- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
I can't find where can i config when the Voltage of VBus exceed to the 20V.
In the usb-pd sepc
The Bits10..9 must be changed when the Vbus voltage exceeds 20V.
Could this function to be added in the updated EZ-PD configuration Unity?
Thanks.
John
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi John,
The Cable VDO you show up is based on PD3.0 SPEC. But CCG2 is support PD2.0. CMG1 (The next E-Marker Cable chip) support PD3.0.
PD2.0 can be download from:http://www.usb.org/developers/powerdelivery/USB_PD_v2.0_011317.zip
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi John,
The Cable VDO you show up is based on PD3.0 SPEC. But CCG2 is support PD2.0. CMG1 (The next E-Marker Cable chip) support PD3.0.
PD2.0 can be download from:http://www.usb.org/developers/powerdelivery/USB_PD_v2.0_011317.zip
Best Regards,
Lisa