Anonymous
Not applicable
Mar 31, 2018
02:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 31, 2018
02:50 AM
I have a CY4532 Demo Board and config to PPS 3.3V to 20V 1A.
I try to get a 1A load in 5V (5 ohm) and send PPS command to 0.1A .
It's no change in 1A.
How can't I get to CC mode?
Solved! Go to Solution.
1 Solution
Apr 01, 2018
07:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2018
07:31 PM
Hi Andrew,
1. PD is support current foldback, not constant current.
2. For standard firmware, the current foldback do not implement. If you have requirements about this, feel free to contact local Cypress for demonstration.
Best Regards,
Lisa
1 Reply
Apr 01, 2018
07:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 01, 2018
07:31 PM
Hi Andrew,
1. PD is support current foldback, not constant current.
2. For standard firmware, the current foldback do not implement. If you have requirements about this, feel free to contact local Cypress for demonstration.
Best Regards,
Lisa