- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello!
Forgive me for maybe a stupid question, but I can't budge. I want to program a microcircuit CY8C20110-SX2I (SOIC-16).
If I understand correctly, the configuration of I/O ports used PSoC Designer and his description page indicates that requires version 5.0 Service Pack 6. But after downloading this software, I can't find my controller (and analogues CY8C201xx) in the list of available devices.
Tell me please what can I do and where I can configure this controller.
Solved! Go to Solution.
- Labels:
-
PSoC 1
-
PSoC 1 Device Programming
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"System Level" should be selected when starting a new project. See the attached application note for PSoC Designer Express tool, which is included in http://www.cypress.com/documentation/application-notes/capsense-express-cy8c201xxx-application-notes
CY8C201xx is not recommended for new design. Try CY8CMBR3xxx family or programmable PSoC 4 family devices.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"System Level" should be selected when starting a new project. See the attached application note for PSoC Designer Express tool, which is included in http://www.cypress.com/documentation/application-notes/capsense-express-cy8c201xxx-application-notes
CY8C201xx is not recommended for new design. Try CY8CMBR3xxx family or programmable PSoC 4 family devices.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
OK, thank you very much for your answer. Not recommended for new Designer? But I was able to configure and program my microcircuit. What can be the problem and which Designer is not new?