Mar 15, 2018
09:18 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 15, 2018
09:18 AM
Hi, i have a FX3 but when i connect the board to the USB3 port the LED 2 (blue) is always off. it happens with or without J4 and J5 jumpers.
I can see the device in USB windows system.
Solved! Go to Solution.
1 Solution
Mar 16, 2018
02:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2018
02:45 AM
Hi,
When the UART_CTS pin on the explorer kit is pulled low, then the Blue LED glows.
You can refer to Super speed explorer kit schematic in the following link:
http://www.cypress.com/file/133841/download
Regards,
Hemanth
Hemanth
1 Reply
Mar 16, 2018
02:45 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2018
02:45 AM
Hi,
When the UART_CTS pin on the explorer kit is pulled low, then the Blue LED glows.
You can refer to Super speed explorer kit schematic in the following link:
http://www.cypress.com/file/133841/download
Regards,
Hemanth
Hemanth