- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I looked at AN72845 and found a recommended land pattern for pins.
However, for thermal pads only the case of 6x6 was listed.
Please tell me about land pattern of thermal vias for CY7C65213-32LTXI(3.5x3.5) thermal pad.
Thanks,
Shimamura
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
At first, a thermal pad dimensions should NOT ideally be less than 5 mm x 5mm.
As comply with this rule, you can prevent unreliable operation of the chip.
If you use 5 mm x 5 mm pad, the 6 mm x 6 mm pattern of the thermal vias will not change since it will be removed the extra part of the pad from around vias itself.
This will ensure that the dimensions of the thermal pad are reduced while maintaining the thermal vias pattern.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
At first, a thermal pad dimensions should NOT ideally be less than 5 mm x 5mm.
As comply with this rule, you can prevent unreliable operation of the chip.
If you use 5 mm x 5 mm pad, the 6 mm x 6 mm pattern of the thermal vias will not change since it will be removed the extra part of the pad from around vias itself.
This will ensure that the dimensions of the thermal pad are reduced while maintaining the thermal vias pattern.
Best regards,
Hirotaka Takayama
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Takayama san,
CY7C65213-32LTXI has a 3.5mm x 3.5mm thermal pad.
Is the recommended vias for this size 3x3 array or 2x2 array?
Thanks,
Shimamrua