- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a CYC8KIT-059 board, and I'm using PSoC creator 4.2. After a while I started getting an error that the firmware was out of date. I finally figured out how to update it using PSoC programmer, but now when I go back to Creator and try to program the device I get the following error:
There was an error while programming the device: PSoC Programmer reported error (100 - FAILED! EraseAll operation failed!
Unknown error)
I am at a loss here. Any help is greatly appreciated.
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This troubleshooting guide might be helpful: Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This troubleshooting guide might be helpful: Troubleshooting PSoC® 3/4/5LP Programming/Debugging Issues - KBA210619