- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I added the new make files to run the snips as mentioned in the introduction video.
Then when I tried to run the "snip.gpio", it said that
"MAKEFILE MAKECMDGOALS = snip.gpio-CYW943907AEVAL1F download run OTA2_SUPPORT is disabled
make: *** Access is denied. "
I don't know what to do for this error. Please help me.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Kindly check the device manager of your laptop and see if the board appears there. If the drivers are installed properly, the device manager should look like this:
In case the drivers are not installed, install it from WICED-Studio-6.0.1\Drivers\Windows\uart.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Kindly check the device manager of your laptop and see if the board appears there. If the drivers are installed properly, the device manager should look like this:
In case the drivers are not installed, install it from WICED-Studio-6.0.1\Drivers\Windows\uart.