Feb 19, 2018
02:12 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 19, 2018
02:12 AM
Please tell us the recommendation of the NC pin on the board.
Is it no problem with floating?
Solved! Go to Solution.
Labels
- Labels:
-
Parallel NOR
1 Solution
Anonymous
Not applicable
Feb 19, 2018
06:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 19, 2018
06:21 PM
Hi,
Yes, NC pin can be left floating. The NC pin is the No Connect pin. There is no internal physical or electrical connection from the die to the lead frame. It is also safe to connect the NC pin with power supply or signal wires.
Thanks,
Nada
1 Reply
Anonymous
Not applicable
Feb 19, 2018
06:21 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 19, 2018
06:21 PM
Hi,
Yes, NC pin can be left floating. The NC pin is the No Connect pin. There is no internal physical or electrical connection from the die to the lead frame. It is also safe to connect the NC pin with power supply or signal wires.
Thanks,
Nada