- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello everyone,
I'm trying to set up a performance test of the CYW920706WCDEVAL board with the Manufacturing Bluetooth Test Tool.
I followed the steps described in /WICED-Studio-6.0/Doc/Manufacturing-Bluetooth-Test-Tool.pdf but whe I run the command mbt reset nothing happens, it gets stuck at:
Sending HCI Command:
0000 < 03 0C 00 >
For more information, the board is programmed with demo.audio.headset-CYW920706WCDEVAL, which is compatible with the HCI controller. All I want to do is get statistics about the received packets (CRC errors, and packet loss, mostly). I use the CYW920706WCDEVAL as an audio sink. The audio source comes from a non-CYW20706 device (smartphone and PC). If you know an efficient way to do so, let me know please.
Setup: Windows 7 x64
Thank you in advance.
Luis CRUZ
Solved! Go to Solution.
- Labels:
-
ispn:38625:1:0
-
l1:314:1:0
- Tags:
- audio sink
- cyw20706
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Luiz,
In the audio.headset app, comment out the wiced_transport_init(&transport_cfg) in hci_control.c.
This will obviously disable the WICED transport and your application won't function as expected but you should be able to use MBT to send HCI commands.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Luis,
When an app is running, the 20706 will not respond to HCI commands on the UART. Any HCI commands sent to the controller will have to come from the embedded application.
Jacob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Luiz,
In the audio.headset app, comment out the wiced_transport_init(&transport_cfg) in hci_control.c.
This will obviously disable the WICED transport and your application won't function as expected but you should be able to use MBT to send HCI commands.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I disabled the external serial flash (U2) with switches SW7 and found that MBT works.