- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I am using WICED Studio 6.0.1 on macOS High Sierra with Inventek ISM4343WBM module.
I can download and run any snippet without any issues. But I am having issues when trying to debug it.
I can start debug session, I see in console:
Program received signal SIGTRAP, Trace/breakpoint trap.
[Switching to Thread 3892325141]
0x0800c66a in _start () at WICED/platform/MCU/STM32F4xx/../../ARM_CM4/crt0_GCC.c:81
81
__asm__( " ldr r1, =link_stack_end\n"
But after that I can't do anything: can't set a breakpoint (it says 'cant access memory at 0x8xxxxx') or resume program execution.
Tried the same with WICED Studio 5.2.1 - and I can't even start a debug session, there are no debug configurations...
Solved! Go to Solution.
- Labels:
-
Debug
-
MAC OSX
-
WICED Studio
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check the debug configuration Re: Debugging the BCM943362WCD4_EVB as mentioned in this thread. Are you using the same debug configuration and still receiving the error?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please check the debug configuration Re: Debugging the BCM943362WCD4_EVB as mentioned in this thread. Are you using the same debug configuration and still receiving the error?