Project with PWM component builds successfully, but notice list flags 2 connection when visible errors, but pins are invisible.

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Working with the PWM component V3.30 in PSoC Creator 4.1 on a PSoC3. It reports to the output window that the build was successful. However in the notice list there are 2 errors. Both are sdbM.0050. One is: Terminal "capture" requires connection when it is visible. The other is: Terminal "trigger" requires connection when it is visible. I have both pins invisible. With the Trigger and Capture function set to 'None' on the Advanced Tab in the configuration dialog. I'd rather not have to make them visible and orchestrate logic to make the part run in just continuous mode. Is there something I've missed?

0 Likes
1 Solution
AnkitaS_51
Employee
Employee
100 likes received 50 likes received 25 likes received

Please close and reopen the creator, Notice list will be cleared

View solution in original post

0 Likes
1 Reply
AnkitaS_51
Employee
Employee
100 likes received 50 likes received 25 likes received

Please close and reopen the creator, Notice list will be cleared

0 Likes