- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We are developing our FCC test firmware for the BCM43341B0. We are building on our original firmware for the 433262a2.
Our problem comes when we try to transmit using 2.4GHz 802.11n with the channel width set to 40MHz (upper or lower sidebands).
The 40MHz width seems to work fine for 802.11a and 802.11n as long as we use 5GHz for the band, and 20MHz width works fine with both bands using any 802.11 data rate (a/b/g/n).
Is 40MHz wide channels currently supported with 2.4GHz? or is this a known deficiency in the BCM43341B0 WICED firmware?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We haven’t done any testing with 40Mhz in 2.4GHz and in general we don’t support it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bump. This should be simple for anyone in the Broadcom Wiced group to answer. We need to know if 40MHz wide channels are supported in the 2.4GHz band for manufacturing and FCC testing.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We haven’t done any testing with 40Mhz in 2.4GHz and in general we don’t support it.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks, we won't present it as a testable option.