Anonymous
Not applicable
Dec 07, 2017
10:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2017
10:16 AM
Hello!
I want to program CY8CMBR3110 with ESP32 from Espressif via I2C.
With the Arduino I can, but not with the ESP32. Wich is th eproblem?
Labels
1 Reply
Feb 03, 2018
03:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 03, 2018
03:13 AM
Hi,
Since you are able to configure the device from Arduino there will not be any problem from our MBR3 device as a slave. Kindly check the firmware of the ESP32 you have and go through the MBR3 CapSense design guide once again and probe the SCL and SDA lines and whether there is problem with I2C communication.
Thanks and Regards
Ganesh