Anonymous
Not applicable
Aug 31, 2015
03:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 31, 2015
03:07 PM
Hi,
I found an example of UART RX/TX in firmware example - cyfxuartlpregmode
I can successfully build the application. But when I run it, I see no receiver output via UART. I am using hyperterminal and I have the same settings as in code. From what I understand, it should transmit back the same bytes I send. But I receive nothing.
Can someone help me fix this issue.
Thanks.
2 Replies
Anonymous
Not applicable
Oct 07, 2015
11:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 07, 2015
11:40 PM
Hi,
Have you found out where exactly the code is getting stuck? (using JTAG Debugger or by some other way). If not, please create a Tech Support Case.
Regards,
-Madhu Sudhan
Jan 30, 2018
08:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 30, 2018
08:03 AM
Even I'm finding the same issue. Would be really helpful, if you could guide me. I have raised a tech support and shared you the case