- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I'm starting to discover the FX3 programation and I have encountered some problems.
I want to program a frame grabber that will get the input of my omnivision camera and send it via usb 3.0.
I use the AN75779 to guide me through this, even if I know this is an outdated document (SDK 1.1).
I use the 1.2 firmware called cyfxuvcinmem.
When loading this project, I had quite a number of errors.
- uint8_t and such not recognized
-NULL not recognized
- Bad input for some #include
I think that I fixed those.
Yet I still have some problems
- A lot of constants are not known
in cyu3uart.c:
CyU3PMutexCreate (&glUartLock, CYU3P_NO_INHERIT);
in cyfxuvcinmem.c:
status = CyU3PDmaChannelGetBuffer (&glChHandleUVCStream, &dmaBuffer, CYU3P_WAIT_FOREVER);
CYU3P_NO_TIME_SLICE, /* No time slice for the application thread */
CYU3P_AUTO_START /* Start the Thread immediately */
in cyfxtx.c:
CyU3PDmaBufMgr_t glBufferManager = {{0}, 0, 0, 0, 0, 0};
status = CyU3PByteAlloc (&glMemBytePool, (void **)&ret_p, size, CYU3P_NO_WAIT);
Have I forgotten an include or something? Thanks for the help
Vincent
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vincent,
Could you please attach the "Problems" and "Console" tab of Eclipse project.
Thanks,
Sai Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The program doesn't seem to fin the makefile, so the console log won't show much I think
------------------------------------------------------------------------------------------------------------------------------
**** Build of configuration Default for project firmware ****
make all
Cannot run program "make": Launching failed
Error: Program "make" is not found in PATH
PATH=
**** Build Finished ****
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not sure if pictures have been attached, second try
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Vincent,
Did you follow the steps mentioned in the following thread:
http://www.cypress.com/?app=forum&id=167&rID=69878
I can build the project attached to AN75779, using SDK 1.2.1 by following the above steps.
Please let me know if that does not help.
Thanks,
Sai Krishna.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sai
I'm confused with the same question . And I can't open the link http://www.cypress.com/?app=forum&id=167&rID=69878