- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm making a few debug/toggle pins for my application. When I assign a toggle pin to port 1 pin 0 (1.0, or 1[0]), it doesn't toggle. when I reassign the same function to, say, pin 1.5, it works fine. I'm not getting any errors or warnings from the compiler.
Just wondering - is pin 1.0 on the PSOC6 board restricted in some way?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
On the CY8CKIT-062-BLE Pioneer kit, P1[0] is multiplexed with CapSense Tx pin. By default this pin is not brought out to the J19 on the kit.
You need to populate R101 (0 ohm) in order to use this pin.
Thanks,
Vaisakh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
On the CY8CKIT-062-BLE Pioneer kit, P1[0] is multiplexed with CapSense Tx pin. By default this pin is not brought out to the J19 on the kit.
You need to populate R101 (0 ohm) in order to use this pin.
Thanks,
Vaisakh