Anonymous
Not applicable
Dec 13, 2017
01:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 13, 2017
01:07 AM
Hello,
Our design configure the pins of the FX3 so that it assumes to use a 26MHz oscillator. In reality a 19.2 MHz device is installed. Is there a way to change this by software?
Thank you
Kind regards
Reto
Solved! Go to Solution.
- Tags:
- external xtal
- fx3
1 Solution
Anonymous
Not applicable
Dec 27, 2017
10:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 27, 2017
10:56 AM
1 Reply
Anonymous
Not applicable
Dec 27, 2017
10:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 27, 2017
10:56 AM
No, FSLC pins are the only way for frequency selection.