Anonymous
Not applicable
Dec 13, 2017
01:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 13, 2017
01:28 AM
Hello,
Our design configure the pins of the FX3 so that it assumes to use a 26MHz oscillator. In reality a 19.2 MHz device is installed. The software starts and also an USB link can be established. But it is not stable.
Is there a way to change the oscillator PLL by software?
Thank you
Kind regards
Reto
Solved! Go to Solution.
1 Solution
Anonymous
Not applicable
Dec 27, 2017
10:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 27, 2017
10:55 AM
No, FSLC pins are the only way for frequency selection.
Regards,
- Madhu Sudhan
1 Reply
Anonymous
Not applicable
Dec 27, 2017
10:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 27, 2017
10:55 AM
No, FSLC pins are the only way for frequency selection.
Regards,
- Madhu Sudhan