- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
When Host MCU is connected to CCG3 with I2C and try to program CCG3, the Host have to communicate CCG3 by HPI protocol but I cannot know the algorithm for the programming.
Please let me know any documentation for the method.
P.S.
I need the two way to program it.
1) Programming .cyacd file generated by EZ configuration Utility.
2) Programming .hex file generated by Creator
Best regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi user_474444345,
1) Programming .cyacd file generated by EZ configuration Utility.
>> The documentation for this is Host Processor Interface user guide. This documentation can get it from CY FAE with NDA.
>> Hardware end, there are a USB to I2C bridge is need. Refer CY7C65215 on CY4531.
2) Programming .hex file generated by Creator
>> This way need MiniProg3 (hardware) and PSoC Programmer (software). Related documentation is CYPD3xxx programming SPEC.
Best Regards,
Lisa