Sep 23, 2013
01:29 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 23, 2013
01:29 PM
Question: Who manufactures the white 6-pin UART connector (labeled JP1) on the BCM920732TAG_Q32 board?ANSWER: JP1 (male pins) on the tag module uses the Molex PN:0533980671 It is paired with Molex PN: 510210600
Solved! Go to Solution.
- Tags:
- 510210600
- 6-pin
- answer
- bcm920732tag_q32
- board
- connector
- jp1
- labeled
- male
- manufactures
- module
- molex
- paired
- pins
- pn0533980671
- q32
- question
- tag
- uart
- white
1 Solution
Oct 29, 2013
07:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 29, 2013
07:49 AM
This is a dummy update/reply to the thread so the "Replies" counter becomes non-zero (the answer to the posting was provided at the same time the thread was created).
2 Replies
Oct 29, 2013
07:49 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 29, 2013
07:49 AM
This is a dummy update/reply to the thread so the "Replies" counter becomes non-zero (the answer to the posting was provided at the same time the thread was created).
Anonymous
Not applicable
Feb 18, 2014
10:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 18, 2014
10:35 AM
Personally I would recommend for future Eval Boards to make use of a 1.27mm pitch connector as this is a relatively common pitch compared to 1.25mm connector which I have never seen used until now...