- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My Pioneer Kit not communicate to PC ( No one port in Teraterm). Status LED blinks slow.
In Guide I see that need " bootload the new .cyacd file using the Bootloader Host tool shipped with PSoC Creator."
I run Bootloader Host tool but it can't communicate by USB because this problem.
So I connected to Kit with MiniProg3 by 5 pin connector (J7) .
I can comunicate to device by this MiniProg3 for write firmware (see attached PK1.png) but Bootloader Host tool can`t ( see attached PK2.png)
Other same Kit is working well so it`s only this Kit problem.
How can I solve this problem ?
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Tags:
- bootloader
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Press the reset button of your pioneer kit for more than 5 seconds until the status LED lights steady. The board seems to be in the memory mode. See kitprog manual.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Press the reset button of your pioneer kit for more than 5 seconds until the status LED lights steady. The board seems to be in the memory mode. See kitprog manual.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WOW ! It`s works !
See what they recommended :
BTW I asked support and they not answered ....
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please try enabling the Show USB Devices option in Port Filter dialog in the Bootloader Host tool (when the kit is in bootloader mode), that will list the kit.
Refer to section 9.1 Building a Custom Bootloadable Application for KitProg2 of the KitProg2 User Guide for details.