Anonymous
Not applicable
Dec 01, 2017
03:15 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 01, 2017
03:15 AM
4 Replies
Anonymous
Not applicable
Dec 01, 2017
07:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 01, 2017
07:35 AM
Try changing the priorities of the interrupts under the System settings in PSoC Creator for the project; You will want the Bluetooth to have a lower value priority to prioritize the bluetooth over the SPI, as the SPI not technically time dependent, but the BLE module's activities are.
Dec 02, 2017
05:58 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2017
05:58 AM
How can I change the priorities?
Is it possible to use SPI macroblock(full duplex) instead of SCB block in Bluetooth application?
Dec 02, 2017
08:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2017
08:07 AM
In the Workspace Explorer in Creator 4. you will find an "Interrupts" entry. There you can change all the used interrupts.
Bob
Dec 04, 2017
08:23 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 04, 2017
08:23 AM
Here is where the interrupt priorities are located:
And SPI communications are always full duplex; I'm not understanding what you mean by the SCB block comment?